Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Like ADS CookBook, is there any help document available for Power Amplifier(PA) Design using MMIC Technology. In ADS CookBook, good example has given to desIgn PA at 1 GHz using Microwave Integrated Circuit (MIC).
Like ADS CookBook, help document available for design at any band PA...
When I do optimization for S11 and S22, I am getting results nicely without any optimization error. I have attached same results below.
But when I include Pdel_dBm, LS_Gain_dB and dBm(Vout) these for optimization. I included correct measurement equations also. I am getting optimization error.
Yes I did mistake. I wanted to type for TL13 W = 890 um instead of 890 mm and L = 14 mm.
After correcting also these, I am getting error.
1699285968
As you said. It is correct. I wanted to type L = 890 um instead of 890 mm and L = 14.3626 mm. But still it is showing error.
Parse Error is showing in line number 50. But when I went and checked showing error in the line number 50. But it seems to be ok. I couldn't find error in MTEE7.
1699009690
Parse Error is showing in line number 50. But when I went and checked showing error in the line number 50. But it seems to...
How to avoid some extra line breaks that cause error. When we go and search line 45 or 50. There are no errors at all.
How to overcome this parse error.
I have simulated once again and attached below the error messages and netlist pdf also.
As you mentioned, I corrected Hu and simulated. But I am not getting problem from Hu. Later I am getting example MLIN2 TL12. Once again I corrected problem of MLIN2 TL12. Next time I am not getting problem from TL12, but am getting TL11. Once I corrected TL11, next time I am getting problem from...
Yes, I have generated Netlist. In the error message, it is showing error in the line number 15. I went and searched line number 15 parameters. Even I checked and changed MSTEP:Step2 N__6 N__10 Subst="MSub1" W1=0.835 mm W2=1.5 mm. But I couldn't able to remove error. I have attached netlist...
I have created sub-circuits for input and output matching of Power Amplifier and also included Optimization. I am getting Parser Error as it is showing Parser Error at line 50. How to remove this Parser Error and how to find out line number in 50 in ADS.
I want to calculate Drain Efficiency(Deff) of PA. I have tried lot to calculate the same. But it is showing error in the equations. Someone can suggest how to calculate the same.
I want to calculate Pdc. From Pdc and Pdel_W, finally, I need to calculate Deff(Drain Efficieny) = 100*Pdel_W/Pdc. I have tried to calculate Pdc in different ways but I am getting red mark. Suggest anybody how to calculate Drain Efficiency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
